alproof tape_roll_installed tri Trendsetter_400/800_Proofing Set to 1 for normal firmware control of hte tape/adhesive roller. Set to 0 when the roller is not installed, or when you want the tape roller to not be used in the media loading/cleaning cycles (like when the tape roller is too sticky and doesn't allow the contact cleaning roller to rotate, for example). When there is no tape roller physically installed and the tape roller arms are empty, they can get caught in the contact cleaning roller mechanism if they are lifted up. Thus the need for this parameter. byte
  • 1
    •
  • 0 to 1 (no units)
    •      cfg
  • ../nvs/proof_cfg_rdc.xmlNVS: proof rdc
  • ../nvs/proof_cfg_rlc.xmlNVS: proof rlc
    •
  • ..\..\ShowAllErrors.htmFirmware 0 Error Index
  • ..\..\ShowAllCommands.htmFirmware 0 Command Index
  • ..\..\ShowAllNVS.htmFirmware 0 NVS Index
    •  Updated: Wed Jul 16 19:36:28 2008 PST